Varying the ratio between the two lets you adjust that power - using 0.1mm for both cut and skip would give you the effect of 50% of your chosen output power, because it is spending exactly half of the time with the power on. This can also be very useful when trying to cut delicate material with a powerful laser - Setting very low cut and skip values, like 0.1mm each, toggles the beam on and off very quickly, and gives you an effectively lower power output. If you are trying to cut fold lines in card stock, stitch holes in leather, or just make dashed lines, perforation mode allows you to choose the distance to cut, followed by the distance to skip. The dotted lines below were generated using a different setting, called Perforation Mode. Sometimes, when cutting thick material, trying to engrave very deep, or using a lower power laser, more than one pass may be necessary. How many times the laser will repeat the shapes on this layer. The onnly difference between surface marking and cutting is the power and speed. If you move slowly and with high power, especially with a CO 2 laser, you will cut deeper, possibly through the material. If you move quickly, or with low power, you will likely just etch the surface (sometimes called vector marking). In this mode, the laser follows the exact path of your design, tracing the lines with the beam enabled at the power you've chosen. The image above shows the settings for 'Line' mode. We've updated the terminology to make it easier for new users. In older versions of LightBurn the 'Line' mode was referred to as 'Cut'.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |